A Portcullis company - serving Miami, FL

Before & After Gallery - Portcullis Gate Repair Miami

Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

Gate Repair Before & After in Miami, FL

Photos tell the truth faster than any promise we could print. Below are real projects our technicians have handled across Miami, from Coral Gables to Kendall to Hialeah. Some gates arrived rusted solid. Others had operator boards fried by salt air or lightning. The after photo is the part we care about: a gate that opens and closes the way it should, with a written Kingswell Guarantee backing the repair.

Call (850) 409-8032

Explore

Styles & brands we work with

Recent Transformations

Swing Gate Actuator Swap in Coral Gables

Before — Swing gate actuator replacement – Coral Gables, Miami. Photo placeholder: before (gate stuck half-open) and after (gate fully closed on new actuator).

The actuator, the motorized arm that physically pushes the gate open, had seized after years of salt air working its way past the seal. The homeowner could hear the motor humming but the gate wouldn’t budge. We pulled the old actuator, installed a new LiftMaster arm matched to the gate’s weight, and replaced the mounting brackets that had started to oval. Total time on site: about three hours. The gate now swings smooth and quiet, and the repair carries our 365-Day Done Right Promise in writing.

Slide Gate Roller and Track Rebuild in Kendall

This steel slide gate in Kendall had worn its rollers down to flat spots, so every open cycle sounded like a train dragging a toolbox. The track was packed with sand and old grease that had hardened into something closer to asphalt. We replaced all four rollers, cleaned and re-greased the track, and adjusted the gate’s height so the chain wasn’t pulling at an angle. The gate now rolls with one hand. Most slide gate roller and track rebuilds in Miami run $280 to $520 parts and labor depending on gate weight and how long the track’s been neglected.

Electric Gate Operator Board Replacement in Hialeah

Lightning doesn’t care about your HOA’s landscaping budget. A strike nearby sent a surge through this Hialeah property’s gate operator and cooked the control board. The gate was dead, locked in whatever position it happened to be in. We traced the surge path, replaced the board, and added a surge protector on the power feed so the next storm doesn’t cost the same repair twice. Dean Prescott has seen this exact failure enough times that we now recommend surge protection on every electric gate operator we touch in Miami-Dade, where afternoon thunderstorms are basically a summer schedule.

Loop Detector Replacement in South Miami

Professional welder performing iron gate repair and metal hinge maintenance — Loop detector replacement – South Miami, Miami. Photo placeholder: before (gate not responding to vehicles) and after (new detector wired and sensing cars on approach).

The gate would open fine from the keypad but refused to budge when a car pulled up. That’s the loop detector, the sensor buried in the driveway that tells the operator a vehicle is waiting. In South Miami, we dug up the old loop wire, which had corroded through where the asphalt met a sprinkler line, and laid a new loop. The gate now senses vehicles every time, and the system is sealed against the moisture that killed the last one. Loop detector work like this typically runs $220 to $380 in Miami including parts, labor, and the saw-cut repair.

Sliding Gate Chain and Sprocket Replacement in Doral

Professional contractor repairing a crack on a metal gate post — Sliding gate chain and sprocket replacement – Doral, Miami. Photo placeholder: before (sagging chain with seized links) and after (new chain tensioned correctly on new sprockets).

A snapped chain on a sliding gate means the gate is going nowhere until someone re-links it or replaces the whole run. In Doral, we found a chain so stretched that re-linking would have been a temporary patch. We replaced the chain, both sprockets, and the tensioner, then set the gate’s open and close limits so it wasn’t slamming into the stops. The written price was agreed before we turned a single wrench. Chain and sprocket replacements in Miami generally run $260 to $480 depending on gate length, and you’ll know the exact number before we start.

Gate Post Straightening and Welding in Little Havana

Two technicians installing a decorative metal driveway gate. — Gate post repair – Little Havana, Miami. Photo placeholder: before (leaning post pulling gate off its hinges) and after (post squared, welded, and gate re-hung level).

A delivery truck clipped this Little Havana swing gate and left the post leaning about four inches out of plumb. The gate still latched, but the hinges were taking weight they were never meant to carry. We cut the post free, reset it in concrete, welded the hinge plates back square, and re-hung the gate so it swings level. This kind of repair is why we always write the price before work begins: once you start digging, you find out what the last contractor buried in there. Not every post repair is the same, but you’ll know the cost before we commit to it.

Want Results Like These?

If your gate is stuck, sagging, grinding, or just not opening the way it should, call Portcullis Gate Repair Miami at (850) 409-8032. We’ll send a uniformed, background-checked technician, give you a written price before any work starts, and back the repair with the Kingswell Guarantee for 365 days. Every Portcullis location is independently owned and operated, but the written guarantee is identical across all of them, and it’s stamped on your invoice. Live person answers, 24 hours a day, even on holidays.

Written by Dean Prescott, Owner at Portcullis Gate Repair Miami, serving Miami since 2008.

Before & after

See the difference